MSI 6741 DRIVER

Position the heatsink onto the retention mechanism. Refer to the hard disk documentation supplied by hard disk vendors for jumper setting instructions. Avoid clearing the CMOS while the system is on; it will damage the mainboard. Mic is a connector for microphones. You can barely see the golden finger if the module is properly inserted in the socket. Follow the instructions below to clear the data:

Uploader: Dagrel
Date Added: 17 April 2012
File Size: 10.98 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 60940
Price: Free* [*Free Regsitration Required]

When you are installing the CPU, make sure the CPU has a heat mssi and a cooling fan attached on the top to prevent overheating.

MSI Ms-6741 K8mm-ilsr Ver 1 Socket 754 Motherboard With BP

Then push down the power supply firmly into the connector. Make sure to raise the lever up to a 90degree angle. Then push mi in until the golden finger on the memory module is deeply inserted in the socket. It supports a three-pin head connector.

If the CPU is correctly installed, the pins should be completely embedded into the socket and can not be seen. You can clear CMOS by shorting pin while the system is off. Memory modules can be installed in any combination as follows: As the CPU is likely to move while the lever is being closed, always close the lever with your fingers pressing tightly on top of the CPU to make sure the CPU is properly and completely embedded into the socket.

New Drivers  RAMON FERREIRO BUS DRIVER DOWNLOAD

If you install two hard disks on cable, you must configure the second drive to Slave mode by setting its jumper. Pull the lever sideways away from the socket.

You must configure second hard drive to Slave mode by setting the jumper accordingly. Connect the fan power cable from the mounted fan to the 3-pin fan power connector on the board. To connect to the ATX power supply, make sure the plug of the power supply is inserted in the proper orientation and the pins are aligned.

Otherwise, the Line-Out connector on the back panel will not function.

MSI MS-6741 Manuals

Mic is a connector for microphones. IDE1 can connect a Master and a Slave drive. If the mainboard has a System Hardware Monitor chipset on-board, you must use a specially designed fan with speed sensor to take advantage of the CPU fan control.

You can attach a serial mouse or other serial devices directly to the connector. It introduces a 66MHz, bit channel for the graphics controller to directly access main memory. Please note that any violation of the correct installation procedures may cause permanent damages to 66741 mainboard.

MS MOTHERBOARD | Emachines MS K8T Motherboard

The third PCI slot supports 2 master devices. You can plug the USB device directly into the connector.

New Drivers  DRIVERS: BROTHER MFC-425CN PRINTER

The CPU can only fit in the correct orientation. Floppy Disk Drive Connector: Each lever can be pressed down in only ONE direction. Line In is used for external CD player, Tape player, or other audio devices. The module will only fit in the right orientation. It’s a community-based project which helps to repair anything. AGP is mei interface specification designed for the throughput demands of 3D graphics.

When adding or removing expansion cards, make sure that you unplug mis power supply first.

MSI Ms K8mm-ilsr Ver 1 Socket Motherboard With BP | eBay

Locate the CPU and its retention mechanism on the motherboard. Also, it provides the instructions on connecting the peripheral devices, such as the mouse, keyboard, etc. Avoid clearing the CMOS while the system is on; it will damage the mainboard. The connector location and pin assignments are as follows: Then return to pin position. If you do not find the heat sink and cooling fan, contact your dealer to purchase and install them before turning on the computer.